Autodesk 12812-051462-9011 User Guide 3 - Page 2286

2 Open another command panel. This turns off Sub-Object selection. If you've turned off Sub-Object selection and object selection is still not restored, one of the following may be true: 3 Your selection is locked. Turn off the Selection Lock toggle on the status line. 4 You've set the Selection Filter in the toolbar to a specific category of object, so you can't select any of the other categories. To fix this, choose All in the Selection Filter list. Coordinate Display Status bar > Coordinate Display area The Coordinate Display area shows the position of the cursor or the status of a transform, and allows entry of new transform values. The information in these fields varies, depending on what you are doing: ■ When you are simply moving the mouse in a viewport, these fields show the current cursor location in absolute world coordinates on page 8174. ■ While you are creating an object, these fields also show the current cursor location in absolute world coordinates. ■ While you are transforming an object by dragging in a viewport, these fields always show coordinates relative to the object's coordinates before the transformation was started. While you are transforming an object, these fields change to spinners on page 73, and you can type values directly in them, as described below in "Using the Coordinate Display for Transform Type-In." This is an easy alternative to using the Transform Type-In dialog on page 944. ■ While a transform button is active and a single object is selected, but you are not dragging the object, these fields show the absolute coordinates for the current transform. See "Interface," below. ■ While a transform button is active and multiple objects are selected, these fields are blank. Coordinate Display | 7541