Autodesk 12812-051462-9011 User Guide 3 - Page 168

Dynamics Properties Rollout Material Editor > Standard material > Dynamics Properties rollout The Dynamics Properties rollout lets you specify surface properties that affect the animation of an object upon collision with another object. If there are no collisions in your simulation, these settings have no effect. The dynamics properties are used by the Dynamics utility on page 3852. Since the Dynamics Properties rollout is available at the top level of any material (including submaterials), you can specify different surface dynamic properties for each face in an object. There are also controls in the Dynamics utility that let you adjust the surface properties at the object level, but only the Materials Editor lets you alter the surface properties at the sub-object level, through use of a Multi/Sub-Object material on page 5720. As a default, the values in the Dynamics Properties rollout provide a surface that's similar to Teflon-coated hardened steel. Interface Bounce Coefficient Sets how far an object bounces after hitting a surface. The higher the value, the greater the bounce. A value of 1 represents a "perfectly elastic collision," or a bounce in which no kinetic energy is lost. Default=1.0. If you've seen the desktop toy with four ball bearings swinging back and forth on strings and hitting one another, you've seen an example that comes very close to a bounce coefficient of 1. Generally, hardened steel or a super ball have a bounce near 1, while lead has a bounce near 0. Static Friction Sets how difficult it is for the object to start moving along a surface. The higher this value, the more difficult. Default=0.0. If something weighs ten pounds and sits on Teflon (a static friction of near 0), it takes almost no force to make it move sideways. On the other hand, if it sits on sandpaper, then the static friction might be very high, on the order Standard Material | 5423