Autodesk 12812-051462-9011 User Guide 3 - Page 1303

Render Setup dialog Batch Render dialog >Time Output Frame Start/End Active Time Segment Defaults to 0 (zero) and the last frame of the animation as set in the Time Configuration dialog on page 7565. Range Defaults to the range of frames specified, such as 0 (zero) To 14 or 6 To 11. The Frame Start and End settings also conform to the current time configuration format; i.e. Frames, SMPTE, Frame:Ticks, or MM:SS:Ticks. Width Allows you to specify a new image width setting if Override Preset is on. If Override Preset is off, this value matches the width set on the Render Setup dialog. Height Allows you to specify a new image height setting if the Override Preset is on. If Override Preset is off, this value matches the height set on the Render Setup dialog. Pixel Aspect Sets the aspect ratio of the pixels for display on another device. The image might look squashed on your display but will display correctly on the device with differently shaped pixels. By default, this mimics the value set on the Render Setup dialog. Name Lets you change the default name of the highlighted task. The default naming structure for camera tasks uses "View" plus an incremented view number, such as View01 or View02. If you want, you can change the task's name to something more descriptive. NOTE After changing the name, you must press Enter for the change to register. NOTE If you're rendering elements on page 6336 as part of the batch, the task name is appended to each rendered element's specified file name. For example, if the task name is View01 and the render element output file name is Test_Diffuse.tga, then the batch-rendered element output becomes Test_Diffuse_View01.tga. If you're rendering an element without specifying a file name for the element, the batch renderer appends the element type to the batch output file name. 6558 | Chapter 20 Rendering