Autodesk 12812-051462-9011 User Guide 3 - Page 1405

By placing Points along the curve, you can drag these points to increase or decrease a colors intensity or to eliminate it altogether. Buttons are available at the bottom of the dialog that allow you to change the display of the dialog. You can also manually enter a horizontal or vertical position by entering a value into the two entry boxes. Interface Move Moves selected points in any direction. Click and hold the Move button to display the flyout where you can select a button to move in any direction, move only in the horizontal direction, or move only in the vertical direction. The Move function remains active until you click another button. The button is yellow while it is active. Scale Point Vertically scales a point up or down. Click once to enable Scale Point. The Scale Point function remains active until you click another button. The button is yellow while it is active. Add Point Allows you to add points anywhere along the Circular Falloff curve. Click and hold the Add Point button to display the flyout where you can select a button to add either a Corner Point or a Bezier Point. Click once to enable Add Point. The Add Point function remains active until you click another button. The button is yellow while it is active. Delete Point Deletes selected points. Horizontal Position Allows you to manually enter a horizontal position value for a selected point. Vertical Position Allows you to manually enter a vertical position value for a selected point. 6660 | Chapter 21 Effects and Environments