Autodesk 12812-051462-9011 User Guide 3 - Page 1215

dialog. If your adapter is not listed, follow the instructions in Windows 2000 documentation on adapter setup. 3 In the list, highlight Internet Protocol (TCP/IP) and click Properties. The Internet Protocol (TCP/IP) Properties dialog appears. 4 Make sure the option "Obtain an IP address automatically" is chosen. 5 Click OK to close each dialog in turn. Windows 2000 finishes configuring the software. 6 Reboot the computer to complete the configuration. 7 Repeat all the steps on this page on every machine in your network. To configure TCP/IP in DHCP mode (Windows XP): 1 From the Windows taskbar, open Start menu > Settings > Network Connections. This opens the Network Connections dialog. 2 Right-click Local Area Connection and click the Properties button. This opens the Local Area Connection Properties dialog. You should see your network adapter card listed as "Connect Using" at the top of this dialog. If your adapter is not listed, follow the instructions in Windows XP documentation on adapter setup. 3 In the list, highlight Internet Protocol (TCP/IP) and click Properties. The Internet Protocol (TCP/IP) Properties dialog appears. 4 Make sure the option "Obtain an IP address automatically" is chosen. 5 Click OK to close each dialog in turn. Windows XP finishes configuring the software. 6 Reboot the computer to complete the configuration. 7 Repeat all the steps on this page on every machine in your network. To configure TCP/IP with fixed IP addresses (Windows 2000): 1 From the Windows taskbar, open Start menu > Settings > Network and Dial-up Connections > Local Area Connection. This opens the Local Area Connection Status dialog. 2 Click the Properties button. 6470 | Chapter 20 Rendering