Netgear GSM4328PB CLI Manual Software Version 12.x - Page 959
time-range, assign-queue, permit, mirror, redirect, value is 0
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 959 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 13. Ethertype keyword and 4-digit hexadecimal value Ethertype Keyword Corresponding Value appletalk 0x809B arp 0x0806 ibmsna 0x80D5 ipv4 0x0800 ipv6 0x86DD ipx 0x8037 mplsmcast 0x8848 mplsucast 0x8847 netbios 0x8191 novell 0x8137, 0x8138 pppoe 0x8863, 0x8864 rarp 0x8035 The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields, respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or outer) tag. The time-range parameter allows imposing time limitation on the MAC ACL rule as defined by the parameter time-range-name. If a time range with the specified name does not exist and the MAC ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied immediately. If a time range with specified name exists and the MAC ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied when the time-range with specified name becomes active. The ACL rule is removed when the time-range with specified name becomes inactive. For information about configuring time ranges, see Time Range Commands for Time-Based ACLs on page 990. The assign-queue parameter allows specification of a particular hardware queue for handling traffic that matches this rule. The allowed queue-id value is 0-(n-1), in which n is the number of user configurable queues available for the hardware platform. The assign-queue parameter is valid only for a permit rule. The mirror parameter allows the traffic matching this rule to be copied to the specified unit/slot/port, while the redirect parameter allows the traffic matching this rule to be forwarded to the specified unit/slot/port. The assign-queue and redirect parameters are only valid for a permit rule. Quality of Service Commands 959 CLI Command Reference Manual