Netgear GSM4328PB CLI Manual Software Version 12.x - Page 915
ipv6 dhcp snooping log-invalid
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 915 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ipv6 dhcp snooping trust Use this command to configure the port as untrusted. Format Mode no ipv6 dhcp snooping trust Interface Config ipv6 dhcp snooping log-invalid Use this command to control the logging DHCP messages filtration by the DHCP Snooping application. This command can be used to configure a single interface or a range of interfaces. Default Format Mode disabled ipv6 dhcp snooping log-invalid Interface Config no ipv6 dhcp snooping log-invalid Use this command to disable the logging DHCP messages filtration by the DHCP Snooping application. Format Mode no ipv6 dhcp snooping log-invalid Interface Config ipv6 dhcp snooping limit Use this command to control the rate at which the DHCP Snooping messages come on an interface or range of interfaces. By default, rate limiting is disabled. When enabled, the rate can range from 0 to 300 packets per second, which is expressed in the pps argument. The burst level range is 1 to 15 seconds, which is expressed in the seconds argument. Rate limiting is configured on a physical port and may be applied to trusted and untrusted ports. Default Format Mode disabled (no limit) ipv6 dhcp snooping limit {rate pps [burst interval seconds]} Interface Config IPv6 Commands 915 CLI Command Reference Manual