Netgear GSM4328PB CLI Manual Software Version 12.x - Page 1122
Table 58., Routing Table Manager Log Messages, Table 59., VRRP Log Messages, Table 60., ARP Log
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1122 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 58. Routing Table Manager Log Messages Component RTO RTO Message Cause RTO is no longer full. Routing table contains xxx best routes, xxx total routes, xxx reserved local routes. When the number of best routes drops below full capacity, RTO logs this notice. The number of bad adds may give an indication of the number of route adds that failed while RTO was full, but a full routing table is only one reason why this count is incremented. RTO is full. Routing table contains xxx best routes, xxx total routes, xxx reserved local routes. The routing table manager stores a limited number of best routes. The count of total routes includes alternate routes, which are not installed in hardware. The routing table manager, also called "RTO," stores a limited number of best routes, based on hardware capacity. When the routing table becomes full, RTO logs this alert. The count of total routes includes alternate routes, which are not installed in hardware. Table 59. VRRP Log Messages Component VRRP VRRP Message VRRP packet of size xxx dropped. Min VRRP packet size is xxx; Max VRRP packet size is xxx. VR xxx on interface xxx started as xxx. VRRP This router is the IP address owner for virtual router xxx on interface xxx. Setting the virtual router priority to xxx. Cause This message appears when there is flood of VRRP messages in the network. This message appears when the Virtual router is started in the role of a Master or a Backup. This message appears when the address ownership status for a specific VR is updated. If this router is the address owner for the VR, set the VR's priority to MAX priority (as per RFC 3768). If the router is no longer the address owner, revert the priority. Table 60. ARP Log Message Component ARP Message IP address conflict on interface xxx for IP address yyy. Conflicting host MAC address is zzz. Cause When an address conflict is detected for any IP address on the switch upon reception of ARP packet from another host or router. Table 61. RIP Log Message Component RIP Message Cause RIP: discard response from xxx via unexpected interface When RIP response is received with a source address not matching the incoming interface's subnet. Switch Software Log Messages 1122 CLI Command Reference Manual