Netgear GSM4328PB CLI Manual Software Version 12.x - Page 868
exit-overflow-interval OSPFv3, external-lsdb-limit OSPFv3, no enable OSPFv3, no exit-overflow-interval
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 868 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no enable (OSPFv3) This command sets the administrative mode of OSPF in the router to inactive. Format Mode no enable Router OSPFv3 Config exit-overflow-interval (OSPFv3) This command configures the exit overflow interval for OSPF. It describes the number of seconds after entering Overflow state that a router will wait before attempting to leave the overflow state. This allows the router to again originate nondefault AS-external-LSAs. When set to 0, the router does not leave overflow state until restarted. The range for seconds is from 0 to 2147483647 seconds. Default Format Mode 0 exit-overflow-interval seconds Router OSPFv3 Config no exit-overflow-interval This command configures the default exit overflow interval for OSPF. Format Mode no exit-overflow-interval Router OSPFv3 Config external-lsdb-limit (OSPFv3) This command configures the external LSDB limit for OSPF. If the value is -1, then there is no limit. When the number of nondefault AS-external-LSAs in a router's link-state database reaches the external LSDB limit, the router enters overflow state. The router never holds more than the external LSDB limit nondefault AS-external-LSAs in it database. The external LSDB limit MUST be set identically in all routers attached to the OSPF backbone and/or any regular OSPF area. The range for limit is from -1 to 2147483647. Default Format Mode -1 external-lsdb-limit limit Router OSPFv3 Config IPv6 Commands 868 CLI Command Reference Manual