Netgear GSM4328PB CLI Manual Software Version 12.x - Page 238
interface or management interface address. When sending a traceroute on a management
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The switch does not accept an incoming packet that arrives on a routing interface if the packet's destination address is on one of the out-of-band management interfaces (service port or network port). An example of such a packet is a traceroute response. Similarly, the switch does not accept a packet that arrives on a management interface if the packet's destination is an address on a routing interface. Thus, it would be futile to send a traceroute on a management interface using a routing interface address as source, or to send a traceroute on a routing interface using a management interface as source. When sending a traceroute on a routing interface, the source must be that routing interface or another routing interface. When sending a traceroute on a management interface, the source must be on that management interface. For this reason, the user cannot specify the source as a management interface or management interface address. When sending a traceroute on a management interface, the user should not specify a source address, but instead let the system select the source address from the outgoing interface. Default Format Mode count: 3 probes interval: 3 seconds size: 0 bytes port: 33434 maxTtl: 30 hops maxFail: 5 probes initTtl: 1 hop traceroute {ip-address | [ipv6] {ipv6-address | hostname}} [initTtl initTtl] [maxTtl maxTtl] [maxFail maxFail] [interval interval] [count count] [port port] [size size] [source {ip-address | ipv6-address | unit/slot/port}] Privileged EXEC Using the options described below, you can specify the initial and maximum time-to-live (TTL) in probe packets, the maximum number of failures before termination, the number of probes sent for each TTL, and the size of each probe. Parameter ipaddress ipv6-address hostname ipv6 initTtl maxTtl maxFail Description The ipaddress value should be a valid IP address. The ipv6-address value should be a valid IPv6 address. The hostname value should be a valid hostname. The optional ipv6 keyword can be used before ipv6-address or hostname. Giving the ipv6 keyword before the hostname tries it to resolve to an IPv6 address. Use initTtl to specify the initial time-to-live (TTL), the maximum number of router hops between the local and remote system. Range is 0 to 255. Use maxTtle to specify the maximum TTL. Range is 1 to 255. Use maxFail to terminate the traceroute after failing to receive a response for this number of consecutive probes. Range is 0 to 255. Utility Commands 238 CLI Command Reference Manual