Netgear GSM4328PB CLI Manual Software Version 12.x - Page 742
ip ospf hello-interval, ip ospf network, broadcast, point-to-point
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 742 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode 40 ip ospf dead-interval seconds Interface Config no ip ospf dead-interval This command sets the default OSPF dead interval for the specified interface. Format Mode no ip ospf dead-interval Interface Config ip ospf hello-interval This command sets the OSPF hello interval for the specified interface or range of interfaces. The value for seconds is a valid positive integer, which represents the length of time in seconds. The value for the period must be the same for all routers attached to a network. Valid values for seconds are in the range from 1 to 65535. Default Format Mode 10 ip ospf hello-interval seconds Interface Config no ip ospf hello-interval This command sets the default OSPF hello interval for the specified interface. Format Mode no ip ospf hello-interval Interface Config ip ospf network Use this command to configure OSPF to treat an interface or range of interfaces as a point-to-point rather than broadcast interface. The broadcast option sets the OSPF network type to broadcast. The point-to-point option sets the OSPF network type to point-to-point. OSPF treats interfaces as broadcast interfaces by default. (Loopback interfaces have a special loopback network type, which cannot be changed.) When there are only two routers on the network, OSPF can operate more efficiently by treating the network as a point-to-point network. For point-to-point networks, OSPF does not elect a designated router or generate a network link state advertisement (LSA). Both endpoints of the link must be configured to operate in point-to-point mode. Routing Commands 742 CLI Command Reference Manual