Netgear GSM4328PB CLI Manual Software Version 12.x - Page 61
serviceport protocol dhcp, mac management address, client-id
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches serviceport protocol dhcp This command enables the DHCPv4 client on a Service port. If the client-id optional parameter is given, the DHCP client messages are sent with the client identifier option. Default Format Mode none serviceport protocol dhcp [client-id] Privileged Exec There is no support for the no form of the command serviceport protocol dhcp client-id. To remove the client-id option from the DHCP client messages, issue the command serviceport protocol dhcp without the client-id option. The command serviceport protocol none can be used to disable the DHCP client and client-id option on the interface. Command example: (NETGEAR Switch) # serviceport protocol dhcp client-id mac management address This command sets locally administered MAC addresses. The following rules apply: • Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered (b'0') or locally administered (b'1'). • Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual address (b'0') or a group address (b'1'). • The second character, of the twelve character macaddr, must be 2, 6, A or E. A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0'). Format Mode mac management address macaddr Privileged EXEC mac management type This command specifies whether the switch uses the burned in MAC address or the locally-administered MAC address. Default Format Mode burnedin mac management type {local | burnedin} Privileged EXEC Management Commands 61 CLI Command Reference Manual