Netgear GSM4328PB CLI Manual Software Version 12.x - Page 696
Virtual LAN Routing Commands
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 696 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Hold Time Preference Definition The amount of time, in seconds, that a system should keep the router advertisement before discarding it. The preference of the address as a default router address, relative to other router addresses on the same subnet. Virtual LAN Routing Commands This section describes the commands you use to view and configure VLAN routing and to view VLAN routing status information. vlan routing This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. The interface-id value has a range from 1 to 128. Typically, you do not supply the interface ID argument, and the system automatically selects the interface ID. However, if you specify an interface ID, the interface ID becomes the port number in the unit/slot/port for the VLAN routing interface. If you select an interface ID that is already in use, the CLI displays an error message and does not create the VLAN interface. For products that use text-based configuration, including the interface ID in the vlan routing command for the text configuration ensures that the unit/slot/port for the VLAN interface stays the same across a restart. Keeping the unit/slot/port the same ensures that the correct interface configuration is applied to each interface when the system restarts. Format Mode vlan routing vlanid [interface-id] VLAN Config no vlan routing This command deletes routing on a VLAN. Format Mode no vlan routing vlanid VLAN Config Command example: The following example specifies a VLAN ID value. The interface ID argument is not used. (NETGEAR Switch)(Vlan)#vlan 14 (NETGEAR Switch)(Vlan)#vlan routing 14 ? Press enter to execute the command. Enter interface ID Routing Commands 696 CLI Command Reference Manual