Netgear GSM4328PB CLI Manual Software Version 12.x - Page 242
of its dynamic VLANs should be deleted., event. Since GVRP is disabled by default
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches clear ipv6 access-list counters This command clears the counters of specific IPv6 ACL or specific IPv6 ACL rule. Format Mode clear ipv6 access-list counters {acl-name | rule-id} Privileged EXEC clear pass This command resets all user passwords to the factory defaults without powering off the switch. You are prompted to confirm that the password reset should proceed. Format Mode clear pass Privileged EXEC clear traplog This command clears the trap log. Format Mode clear traplog Privileged EXEC clear vlan This command resets VLAN configuration parameters to the factory defaults. When the VLAN configuration is reset to the factory defaults, there are some scenarios regarding GVRP and MVRP that happen due to this: 1. Static VLANs are deleted. 2. GVRP is restored to the factory default as a result of handling the VLAN RESTORE NOTIFY event. Since GVRP is disabled by default, this means that GVRP should be disabled and all of its dynamic VLANs should be deleted. 3. MVRP is restored to the factory default as a result of handling the VLAN RESTORE NOTIFY event. Since MVRP is enabled by default, this means that any VLANs already created by MVRP are unaffected. However, for customer platforms where MVRP is disabled by default, then the MVRP behavior should match GVRP. That is, MVRP is disabled and the MVRP VLANs are deleted. Format Mode clear vlan Privileged EXEC Utility Commands 242 CLI Command Reference Manual