Netgear GSM4328PB CLI Manual Software Version 12.x - Page 368
Port Configuration Commands
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 368 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Port Configuration Commands This section describes the commands you use to view and configure port settings. interface (Global Config) This command gives you access to the Interface Config mode, which allows you to enable or modify the operation of an interface (port). You can also specify a range of ports to configure at the same time by specifying the starting unit/slot/port and ending unit/slot/port, separated by a hyphen. Format Mode interface {unit/slot/port | unit/slot/port-unit/slot/port} Global Config Command example: The following example enters Interface Config mode for port 1/0/1: (NETGEAR Switch) #configure (NETGEAR Switch) (config)#interface 1/0/1 (NETGEAR Switch) (interface 1/0/1)# Command example: The following example enters Interface Config mode for ports 1/0/1 through 1/0/4: (NETGEAR Switch) #configure (NETGEAR Switch) (config)#interface 1/0/1-1/0/4 (NETGEAR Switch) (interface 1/0/1-1/0/4)# auto-negotiate This command enables automatic negotiation on a port or range of ports. Default Format Mode enabled auto-negotiate Interface Config Switching Commands 368 CLI Command Reference Manual