Netgear GSM4328PB CLI Manual Software Version 12.x - Page 916
ipv6 verify source, ipv6 verify binding
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 916 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ipv6 dhcp snooping limit Use this command to set the rate at which the DHCP Snooping messages come, and the burst level, to the defaults. Format Mode no ipv6 dhcp snooping limit Interface Config ipv6 verify source Use this command to configure the IPv6SG source ID attribute to filter the data traffic in the hardware. Source ID is the combination of IP address and MAC address. Normal command allows data traffic filtration based on the IP address. With the port-security option, the data traffic is filtered based on the IP and MAC addresses. This command can be used to configure a single interface or a range of interfaces. Default Format Mode the source ID is the IP address ipv6 verify source {port-security} Interface Config no ipv6 verify source Use this command to disable the IPv6SG configuration in the hardware. You cannot disable port-security alone if it is configured. Format Mode no ipv6 verify source Interface Config ipv6 verify binding Use this command to configure static IPv6 source guard (IPv6SG) entries. Format Mode ipv6 verify binding mac-address vlan vlan-id ipv6-address interface interface-id Global Config no ipv6 verify binding Use this command to remove the IPv6SG static entry from the IPv6SG database. Format Mode no ipv6 verify binding mac-address vlan vlan-id ipv6-address interface interface-id Global Config IPv6 Commands 916 CLI Command Reference Manual