Netgear GSM4328PB CLI Manual Software Version 12.x - Page 66
serviceport ipv6 address
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no serviceport ipv6 enable Use this command to disable IPv6 operation on the service port. Format Mode no serviceport ipv6 enable Privileged EXEC serviceport ipv6 address Use the options of this command to manually configure IPv6 global address, enable/disable stateless global address autoconfiguration and to enable/disable dhcpv6 client protocol information on the service port. Note: Multiple IPv6 prefixes can be configured on the service port. no serviceport ipv6 address Use the command no serviceport ipv6 address to remove all configured IPv6 prefixes on the service port interface. Use the command with the address option to remove the manually configured IPv6 global address on the network port interface. Use the command with the autoconfig option to disable the stateless global address autoconfiguration on the service port. Use the command with the dhcp option to disable the dhcpv6 client protocol on the service port. Format Mode no serviceport ipv6 address {address/prefix-length [eui64] | autoconfig | dhcp} Privileged EXEC serviceport ipv6 gateway Use this command to configure IPv6 gateway information (that is, default routers information) for the service port. Note: Only a single IPv6 gateway address can be configured for the service port. There may be a combination of IPv6 prefixes and gateways that are explicitly configured and those that are set through auto-address configuration with a connected IPv6 router on their service port interface. Management Commands 66 CLI Command Reference Manual