Netgear GSM4328PB CLI Manual Software Version 12.x - Page 1093
poe power limit, user-defined, class-based
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1093 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode dot3at poe high-power {legacy | pre-dot3at | dot3at} Interface Config no poe high-power Use this command to disable the high-power mode. The port will support only IEEE 902.3af devices. This command works on a global basis or per interface. Format Mode no poe high-power Interface Config poe power limit Use this command to configure the type of power limit for a port. If the power limit type is user-defined, the command also allows you to configure a maximum power limit. There are three options: • class-based-Allows the port to draw up to the maximum power based on the classification of the device connected. • none-Allows the port to draw up to Class 0 maximum power if it is in low-power mode and up to Class 4 maximum power if it is in high-power mode. • user-defined-Allows you to define the maximum power to the port. This can be a value from 3 through 32 watts. Therefore, the range is 3000-32000. Default Format Mode Class-based poe power limit {class-based | none | user-defined maximum-power} Global Config Interface Config no poe power limit Use this command to set the power limit type to the default. It also sets the maximum power limit to the default if the power limit type is user-defined. Format Mode no poe power limit [user-defined] Global Config Interface Config Power over Ethernet Commands 1093 CLI Command Reference Manual