Netgear GSM4328PB CLI Manual Software Version 12.x - Page 143
radius server host, no radius server attribute 4
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no radius server attribute 4 The no radius server attribute 4 command disables the NAS-IP-Address attribute global parameter for RADIUS client. When this parameter is disabled, the RADIUS client does not send the NAS-IP-Address attribute in RADIUS requests. Format Mode no radius server attribute 4 [ipaddr] Global Config Command example: (NETGEAR Switch) (Config) #radius server attribute 4 192.168.37.60 (NETGEAR Switch) (Config) #radius server attribute 4 radius server host This command configures the IP address or DNS name to use for communicating with the RADIUS server of a selected server type. While configuring the IP address or DNS name for the authenticating or accounting servers, you can also configure the port number and server name. If the authenticating and accounting servers are configured without a name, the command uses the Default_RADIUS_Auth_Server and Default_RADIUS_Acct_Server as the default names, respectively. The same name can be configured for more than one authenticating servers and the name should be unique for accounting servers. The RADIUS client allows the configuration of a maximum 32 authenticating and accounting servers. If you use the auth parameter, the command configures the IP address or host name to use to connect to a RADIUS authentication server. You can configure up to three servers per RADIUS client. If the maximum number of configured servers is reached, the command fails until you remove one of the servers by issuing the no form of the command. If you use the optional port parameter, the command configures the UDP port number to use when connecting to the configured RADIUS server. For the port keyword, the number argument must be a value in the range 0-65535, with 1813 being the default. Note: To reconfigure a RADIUS authentication server to use the default UDP port, set the number argument to 1812. If you use the acct token, the command configures the IP address or host name to use for the RADIUS accounting server. You can only configure one accounting server. If an accounting server is currently configured, use the no form of the command to remove it from the configuration. The IP address or host name you specify must match that of a previously configured accounting server. If you use the optional port parameter, the command configures the UDP port to use when connecting to the RADIUS accounting server. If a port is already configured for the accounting server, the new port replaces the previously configured port. For the port keyword, the number argument must be a value in the range 0-65535, with 1813 being the default. Management Commands 143 CLI Command Reference Manual