Netgear GSM4328PB CLI Manual Software Version 12.x - Page 37
you specify the unit value. For units that lack a matching stack template ID and can therefore
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches If you supply a value for cardindex, the following output displays: Term Card Type Model Identifier Card Description Definition The 32-bit numeric card type for the supported card. The model identifier for the supported card type. The description for the supported card type. show switch Use this command to display information about all units in the stack or about a single unit if you specify the unit value. For units that lack a matching stack template ID and can therefore not join the stack, the switch status is shown as "STM Mismatch." Format Mode show switch [unit] Privileged EXEC Term Switch Definition The unit identifier assigned to the switch. If you do not specify a value for unit, the following information displays: Term Definition Management Status Indicates whether the switch is the Primary Management Unit, a stack member, or the status is unassigned. Preconfigured Model Identifier The model identifier of a preconfigured switch ready to join the stack. The model identifier is a 32-character field that is assigned by the device manufacturer to identify the device. Plugged-In Model The model identifier of the switch in the stack. The model identifier is a 32-character Identifier field that is assigned by the device manufacturer to identify the device. Switch Status The switch status. Possible values for this state are: OK, Unsupported, Code Mismatch, Config Mismatch, or Not Present. A mismatch indicates that a stack unit is running a different firmware version, Switch Database Management (SDM) template, or configuration than the management unit. The SDM Mismatch status indicates that the unit joined the stack, but is running a different SDM template than the management unit. This status is temporary; the stack unit automatically reloads using the template that is running on the stack manager. If a Stacking Firmware Synchronization operation is in progress, the status is shown as Updating Code. Code Version The detected version of code on the switch. Stacking Commands 37 CLI Command Reference Manual