Netgear XSM4324S CLI Manual Software Version 12.x - Page 930
traffic-shape, show classofservice dot1p-mapping, for a specific interface.
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 930 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no random-detect queue-parms Use this command to set the WRED configuration back to the default. Format Modes no random-detect queue-parms queue-id-1 [queue-id-2 ... queue-id-n] Global Config Interface Config traffic-shape This command specifies the maximum transmission bandwidth (bw) limit for the interface as a whole. The bandwidth values are from 0-100 in increments of 1. You can also specify this value for a range of interfaces or all interfaces. Also known as rate shaping, traffic shaping has the effect of smoothing temporary traffic bursts over time so that the transmitted traffic rate is bounded. Format Modes traffic-shape bw Global Config Interface Config no traffic-shape This command restores the interface shaping rate to the default value. Format Modes no traffic-shape Global Config Interface Config show classofservice dot1p-mapping This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a specific interface. The unit/slot/port parameter is optional and is only valid on platforms that support independent per-port class of service mappings. If specified, the 802.1p mapping table of the interface is displayed. If omitted, the most recent global configuration settings are displayed. For more information, see Voice VLAN Commands on page 439. Format Mode show classofservice dot1p-mapping [unit/slot/port] Privileged EXEC Quality of Service Commands 930 CLI Command Reference Manual