Netgear XSM4324S CLI Manual Software Version 12.x - Page 147
radius source-interface, radius server timeout, no radius server retransmit
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no radius server retransmit The no version of this command sets the value of this global parameter to the default value. Format Mode no radius server retransmit Global Config radius source-interface Use this command to specify the physical or logical interface to use as the RADIUS client source interface (Source IP address). If configured, the address of source Interface is used for all RADIUS communications between the RADIUS server and the RADIUS client. The selected source-interface IP address is used for filling the IP header of RADIUS management protocol packets. This allows security devices (firewalls) to identify the source packets coming from the specific switch. If a source-interface is not specified, the primary IP address of the originating (outbound) interface is used as the source address. If the configured interface is down, the RADIUS client falls back to its default behavior. Format Mode radius source-interface {unit/slot/port | loopback loopback-id | vlan vlan-id | serviceport} Global Config Parameter unit/slot/port loopback-id vlan-id Description The unit identifier assigned to the switch. Configures the loopback interface. The range of the loopback ID is 0 to 7. Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to 4093. no radius source-interface Use this command to reset the RADIUS source interface to the default settings. Format Mode no radius source-interface Global Config radius server timeout This command configures the global parameter for the RADIUS client that specifies the time-out value (in seconds) after which a request must be retransmitted to the RADIUS server if no response is received. The time-out value is an integer in the range of 1 to 30 seconds. Management Commands 147 CLI Command Reference Manual