Netgear XSM4324S CLI Manual Software Version 12.x - Page 431
switchport trunk native vlan, switchport access vlan
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 431 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter remove except van-list Description Removes the defined list of VLANs from those currently set instead of replacing the list. Valid IDs are from 1 to 4093. Extended-range VLAN IDs of the form XY or X,Y,Z are valid in this command Lists the VLANs that must be calculated by inverting the defined list of VLANs. (VLANs are added except the ones specified.) Either a single VLAN number from 1 to 4093 or a continuous range of VLANs described by two VLAN numbers, the lesser one first, separated by a hyphen. no switchport trunk allowed vlan This command resets the list of allowed VLANs on the trunk port to its default value. Format Mode no switchport trunk allowed vlan Interface Config switchport trunk native vlan Use this command to configure the trunk port native VLAN (PVID) parameter of the switch port. Any ingress untagged packets on the port are tagged with the value of the native VLAN. The native VLAN must be in the allowed VLAN list for tagging of received untagged packets. Otherwise, untagged packets are discarded. Packets marked with the native VLAN are transmitted untagged from the trunk port. The default ID is 1, the default VLAN. Default Format Mode 1 (default VLAN) switchport trunk native vlan vlan-id Interface Config no switchport trunk native vlan Use this command to reset the trunk mode native VLAN of the switch port to its default value. Format Mode no switchport trunk native vlan Interface Config switchport access vlan Use this command to configure the VLAN on the access port. You can assign one VLAN only to the access port. The access port is member of VLAN 1 by default. You can assign the access port to a VLAN other than VLAN 1. If you remove the access VLAN on the switch, the access port becomes a member of VLAN 1. If you configure the access port as a member of a VLAN that does not exist, an error occurs and the configuration does not change. Switching Commands 431 CLI Command Reference Manual