Netgear XSM4324S CLI Manual Software Version 12.x - Page 167
openflow default-table, openflow ip-mode, full-match, layer-2-match, openflow static-ip
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches openflow default-table This command configures the OpenFlow hardware table. This table is used as the target for flows that are installed by an OpenFlow 1.0 controller that is not enhanced to handle multiple hardware tables. The full-match and layer-2-match keywords are applicable only in OpenFlow mode 1.0. Default Format Mode full-match openflow default-table {full-match | layer-2-match} Global Config openflow ip-mode This command directs OpenFlow to use the configured IP address: • auto. OpenFlow uses the IP address of the management interface. • static. OpenFlow uses the static IP address that you can specify by entering the openflow static-ip command. • serviceport. OpenFlow uses the IP address of the service port. Issuing this command when OpenFlow is already enabled causes the feature to be disabled and reenabled with the new IP address. Default Format Mode auto openflow ip-mode {auto | static | serviceport} Global Config no openflow ip-mode This command resets the OpenFlow IP mode to the default (auto). Format Mode no openflow ip-mode Global Config openflow passive-mode This command enables OpenFlow passive mode. Format Mode openflow passive-mode Global Config Management Commands 167 CLI Command Reference Manual