Netgear XSM4324S CLI Manual Software Version 12.x - Page 65
IPv6 Management Commands
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches IPv6 Management Commands IPv6 management commands allow a device to be managed via an IPv6 address in a switch or through IPv4 routing (that is, independent from the IPv6 routing package). For Routing/IPv6 builds of the switch software, dual IPv4/IPv6 operation over the service port is enabled. The switch software provides capabilities such as the following" • Static assignment of IPv6 addresses and gateways for the service/network ports. • The ability to ping an IPv6 link-local address over the service/network port. • Using IPv6 management commands, you can send SNMP traps and queries via the service/network port. • The user can manage a device via the network port (in addition to a Routing Interface or the Service port). ipv6 management Use this command to create an IPv6 management interface, enable IPv6 and DHCPv6 on the management interface, and delete a previous IPv6 management interface, if there was any. (The switch does not provide a default IPv6 management interface.) Format Mode ipv6 management {vlan number | port unit/slot/port} {autoconfig | dhcp | prefix prefix-length} Global Config no ipv6 management Use this command to reset the IPv6 management interface to the default settings, that is, remove the IPv6 management interface. (The switch does not provide a default IPv6 management interface.) Format Mode no ipv6 management Global Config serviceport ipv6 enable Use this command to enable IPv6 operation on the service port. By default, IPv6 operation is enabled on the service port. Default Format Mode enabled serviceport ipv6 enable Privileged EXEC Management Commands 65 CLI Command Reference Manual