Netgear XSM4324S CLI Manual Software Version 12.x - Page 549
ip arp inspection trust, ARP Inspection.
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 549 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches ip arp inspection trust Use this command to configure an interface or range of interfaces as trusted for Dynamic ARP Inspection. Default Format Mode Disabled ip arp inspection trust Interface Config no ip arp inspection trust Use this command to configure an interface as untrusted for Dynamic ARP Inspection. Format Mode no ip arp inspection trust Interface Config ip arp inspection limit Use this command to configure the rate limit and burst interval values for an interface or range of interfaces. Configuring none for the limit means the interface is not rate limited for Dynamic ARP Inspections. The maximum pps value shown in the range for the rate option might be more than the hardware allowable limit. Therefore you need to understand the switch performance and configure the maximum rate pps accordingly. Note: The user interface accepts a rate limit for a trusted interface, but the limit is not enforced unless the interface is configured to be untrusted. Default Format Mode 15 pps for rate and 1 second for burst-interval. ip arp inspection limit {rate pps [burst interval seconds] | none} Interface Config no ip arp inspection limit Use this command to set the rate limit and burst interval values for an interface to the default values of 15 pps and 1 second, respectively. Format Mode no ip arp inspection limit Interface Config Switching Commands 549 CLI Command Reference Manual