Netgear XSM4324S CLI Manual Software Version 12.x - Page 303
debug sflow packet, Use this command to enable sFlow debug packet trace.
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 303 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The following parameters are displayed in the trace message. Parameter Definition TX/RX TX refers to a packet transmitted by the device. RX refers to packets received by the device. Intf The interface that the packet came in or went out on. Src_IP The source IP address in the IP header of the packet. Dest_IP The destination IP address in the IP header of the packet. Rip_Version RIP version used: RIPv1 or RIPv2. Packet_Type Type of RIP packet: RIP_REQUEST or RIP_RESPONSE. Routes Up to 5 routes in the packet are displayed in the following format: • Network. a.b.c.d • Mask. a.b.c.d • Next Hop. a.b.c.d • Metric. a The next hop is only displayed if it is different from 0.0.0.0. For RIPv1 packets, Mask is always 0.0.0.0. Number of routes Only the first five routes present in the packet are included in the trace. There is another notification not printed of the number of additional routes present in the packet that were not included in the trace. no debug rip packet This command disables tracing of RIP requests and responses. Format Mode no debug rip packet Privileged EXEC debug sflow packet Use this command to enable sFlow debug packet trace. Note: To display the debug trace, enable the debug console command. Default Format Mode disabled debug sflow packet Privileged EXEC Utility Commands 303 CLI Command Reference Manual