Netgear XSM4324S CLI Manual Software Version 12.x - Page 512
port lacpmode enable all, port lacptimeout Interface Config
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 512 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no port lacpmode This command disables Link Aggregation Control Protocol (LACP) on a port. Format Mode no port lacpmode Interface Config port lacpmode enable all This command enables Link Aggregation Control Protocol (LACP) on all ports. Format Mode port lacpmode enable all Global Config no port lacpmode enable all This command disables Link Aggregation Control Protocol (LACP) on all ports. Format Mode no port lacpmode enable all Global Config port lacptimeout (Interface Config) This command sets the timeout on a physical interface or range of interfaces of a particular device type (actor or partner) to either long or short timeout. Default Format Mode long port lacptimeout {actor | partner} {long | short} Interface Config no port lacptimeout This command sets the timeout back to its default value on a physical interface of a particular device type (actor or partner). Format Mode no port lacptimeout {actor | partner} Interface Config Note: Both the no portlacptimeout and the no lacp actor admin state commands set the values back to default, regardless of the command used to configure the ports. Consequently, both commands display in the output of the show running-config command. Switching Commands 512 CLI Command Reference Manual