Netgear XSM4324S CLI Manual Software Version 12.x - Page 1119
QoS
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1119 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 51. Protocol-based VLANs Log Messages Component Protocol Based VLANs Protocol Based VLANs Protocol Based VLANs Message pbVlanCnfgrInitPhase2Process: Unable to register NIM callback pbVlanCnfgrInitPhase2Process: Unable to register pbVlan callback with VLANs pbVlanCnfgrInitPhase2Process: Unable to register pbVlan callback with nvStore QoS Cause Appears when nimRegisterIntfChange fails to register pbVlan for link state changes. Appears when VLANRegisterForChange fails to register pbVlan for VLAN changes. Appears when nvStoreRegister fails to register save and restore functions for configuration save. Table 52. ACL Log Messages Component ACL ACL ACL ACL Message Cause Total number of ACL rules (x) exceeds max (y) on intf i. The combination of all ACLs applied to an interface has resulted in requiring more rules than the platform supports. ACL name, rule x: This rule is not being logged The ACL configuration has resulted in a requirement for more logging rules than the platform supports. The specified rule is functioning normally except for the logging action. aclLogTask: error logging ACL rule trap for correlator number The system was unable to send an SNMP trap for this ACL rule which contains a logging attribute. IP ACL number: Forced truncation of one or more rules during config migration While processing the saved configuration, the system encountered an ACL with more rules than is supported by the current version. This may happen when code is updated to a version supporting fewer rules per ACL than the previous version. Table 53. CoS Log Message Component COS Message cosCnfgrInitPhase3Process: Unable to apply saved config -- using factory defaults Cause The COS component was unable to apply the saved configuration and has initialized to the factory default settings. Switch Software Log Messages 1119 CLI Command Reference Manual