Netgear XSM4324S CLI Manual Software Version 12.x - Page 728
area virtual-link transmit-delay OSPF, auto-cost OSPF, auto-cost reference bandwidth, bandwidth
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 728 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no area virtual-link retransmit-interval This command configures the default retransmit interval for the OSPF virtual interface on the virtual interface identified by area-id and neighbor. The neighbor parameter is the Router ID of the neighbor. Format Mode no area area-id virtual-link neighbor retransmit-interval Router OSPF Config area virtual-link transmit-delay (OSPF) This command configures the transmit delay for the OSPF virtual interface on the virtual interface identified by area-id and neighbor. The neighbor parameter is the Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour). Default Format Mode 1 area area-id virtual-link neighbor transmit-delay seconds Router OSPF Config no area virtual-link transmit-delay This command resets the default transmit delay for the OSPF virtual interface to the default value. Format Mode no area area-id virtual-link neighbor transmit-delay Router OSPF Config auto-cost (OSPF) By default, OSPF computes the link cost of each interface from the interface bandwidth. Faster links have lower metrics, making them more attractive in route selection. The configuration parameters in the auto-cost reference bandwidth and bandwidth commands give you control over the default link cost. You can configure for OSPF an interface bandwidth that is independent of the actual link speed. A second configuration parameter allows you to control the ratio of interface bandwidth to link cost. The link cost is computed as the ratio of a reference bandwidth to the interface bandwidth (ref_bw / interface bandwidth), in which interface bandwidth is defined by the bandwidth command. Because the default reference bandwidth is 100 Mbps, OSPF uses the same default link cost for all interfaces whose bandwidth is 100 Mbps or greater. Use the auto-cost command to change the reference bandwidth, specifying the reference bandwidth in megabits per second (Mbps). For the mbps parameter, the reference bandwidth range is 1-4294967 Mbps. Routing Commands 728 CLI Command Reference Manual