Netgear XSM4324S CLI Manual Software Version 12.x - Page 1064
ipv6 pim dr-priority
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1064 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode Disabled ipv6 pim bsr-candidate interface {unit/slot/port | vlan vland-id} hash-mask-length [bsr-priority] [interval interval] Global Config Parameters Description unit/slot/port Interface or VLAN number on this router from which the BSR address is derived, to make it a candidate. This interface or VLAN must be enabled with PIM. hash-mask-length Length of a mask (32 bits maximum) that is to be ANDed with the group address before the hash function is called. All groups with the same seed hash correspond to the same RP. For example, if this value was 24, only the first 24 bits of the group addresses matter. This allows you to get one RP for multiple groups. bsr-priority [Optional] Priority of the candidate BSR. The range is an integer from 0 to 255. The BSR with the larger priority is preferred. If the priority values are the same, the router with the larger IPv6 address is the BSR. The default value is 0. interval [Optional] Indicates the BSR candidate advertisement interval. The range is from 1 to 16383 seconds. The default value is 60 seconds. Command example: (NETGEAR) (Config) #ipv6 pim bsr-candidate interface 1/0/1 32 5 (NETGEAR) (Config) #ipv6 pim bsr-candidate interface 1/0/1 32 5 interval 100 no ipv6 pim bsr-candidate This command is used to remove the configured PIM Candidate BSR router. Format Mode no ipv6 pim bsr-candidate interface {unit/slot/port | vlan vland-id} Global Config ipv6 pim dr-priority Use this command to set the priority value for which a router is elected as the designated router (DR). The priority argument is a value in the range of 0-2147483647. Note: This command takes effect only when PIM-SM is enabled in the Global mode. IPv6 Multicast Commands 1064 CLI Command Reference Manual