Netgear XSM4324S CLI Manual Software Version 12.x - Page 660
ip load-sharing, ip unnumbered gratuitous-arp accept, ip unnumbered loopback
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 660 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches ip load-sharing This command configures the IP equal-cost multipath (ECMP) load balancing mode. Default Format Mode 6 ip load-sharing mode {inner | outer} Global Config Parameter mode inner outer Description • 1. The mode is based on a hash using the source IP address of the packet. • 2. The mode is based on a hash using the destination IP address of the packet. • 3. The mode is based on a hash using the source and destination IP addresses of the packet. • 4. The mode is based on a hash using the source IP address and the Source TCP/UDP Port field of the packet. • 5. The mode is based on a hash using the destination IP address and the Destination TCP/UDP Port field of the packet. • 6. The mode is based on a hash using the source and destination IP addresses and the Source and Destination TCP/UDP Port fields of the packet. The inner IP header is used for tunneled packets. The outer IP header is used for tunneled packets. no ip load-sharingThis command resets the IP ECMP load balancing mode to default mode (6). Format Mode no ip load-sharing Global Config ip unnumbered gratuitous-arp accept This command enables the switch to automatically configure static interface routes to an unnumbered peer when the switch dynamically receives gratuitous ARP messages. The switch uses the IP address of the loopback interface (see the ip unnumbered loopback command) as the IP address for the unnumbered peer. This behavior is enabled by default. Format Mode ip unnumbered gratuitous-arp accept Interface Config Routing Commands 660 CLI Command Reference Manual