Netgear XSM4324S CLI Manual Software Version 12.x - Page 379
Port Link Flap Commands
View all Netgear XSM4324S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 379 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The output of the show slot number command for a slot in which a TPM404H HDMI port card is installed displays information about the port card, as shown in the following example: (M4300-96X) #show slot 1/5 Slot 1/5 Slot Status Full Admin State Enable Power State Enable Inserted Card: Model Identifier TPM404H Card Description TPM404H HDMI 4-port card Configured Card: Model Identifier TPM404H Card Description TPM404H HDMI 4-port card Power Down Yes Serial Number HZ80K800001A Vendor Name ZeeVee Manufacturer ID 1 FPGA Version 4.0.0.106.0.0.0.0 Software Version 1.0.6.0 Board Revision ID 2 Product Name Z4KNGENC4 Product Description 4-HDMI Interfaces In with 4 IR Out and 1 IR In Note: In the previous example for model M4300-96X, a third-party HDMI port card is shown in slot 1/5. You can insert a third-party HDMI port card in any of the upper slots (1-6), but not in the lower slots. Port Link Flap Commands The switch can detect the number of link-flaps that occur on all ports. If the number of link-flaps on a port exceeds a configured threshold during a configured period, the port can be placed in the D-Disable state. By enabling auto-recovery, the port can automatically be activated again. You can also activate the port manually. Switching Commands 379 CLI Command Reference Manual