Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 997
identifies the OSPF area, This command displays information about the area.
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 997 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches Term Next Hop Next Hop Intf Definition Next hop toward the destination. The outgoing router interface to use when forwarding traffic to the next hop. show ipv6 ospf area This command displays information about the area. The area-id identifies the OSPF area that is being displayed. Format Modes show ipv6 ospf area area-id Privileged EXEC User EXEC Term Definition AreaID The area id of the requested OSPF area. External Routing A number representing the external routing capabilities for this area. Spf Runs The number of times that the intra-area route table has been calculated using this area's link-state database. Area Border Router The total number of area border routers reachable within this area. Count Area LSA Count Total number of link-state advertisements in this area's link-state database, excluding AS External LSAs. Area LSA Checksum A number representing the Area LSA Checksum for the specified area ID excluding the external (LS type 5) link-state advertisements. Stub Mode Represents whether the specified Area is a stub area or not. The possible values are enabled and disabled. This is a configured value. Import Summary LSAs Shows whether to import summary LSAs (enabled). OSPF Stub Metric The metric value of the stub area. This field displays only if the area is a configured as a stub area. Value The following OSPF NSSA specific information displays only if the area is configured as an NSSA. Term Definition Import Summary LSAs Shows whether to import summary LSAs into the NSSA. Redistribute into NSSA Shows whether to redistribute information into the NSSA. Default Information Shows whether to advertise a default route into the NSSA. Originate IPv6 Commands 997