Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 980

M5300, M6100, and M7100 Series ProSAFE Managed Switches no passive-interface Use this command to set the interface, VLAN, or tunnel as nonpassive. It overrides the global passive mode that is currently effective on the interface or tunnel. Format Mode no passive-interface {unit/slot/port | vlan vlan-id | tunnel tunnel-id} Router OSPFv3 Config redistribute (OSPFv3) This command configures the OSPFv3 protocol to allow redistribution of routes from the specified source protocol/routers. The metric argument can be a number in the range 0-16777214. The metric type can be 1 or 2. The tag argument can be a number in the range 0-4294967295. Default Format Mode metric-unspecified type-2 tag-0 redistribute {static | connected} [metric metric] [metric-type {1 | 2}] [tag taq] Router OSPFv3 Config no redistribute This command configures OSPF protocol to prohibit redistribution of routes from the specified source protocol/routers. Format Mode no redistribute {static | connected} [metric] [metric-type] [tag] Router OSPFv3 Config router-id (OSPFv3) This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The ipaddress is a configured value. Format Mode router-id ipaddress Router OSPFv3 Config timers pacing lsa-group (OSPFv3) Use this command to adjust how OSPFv3 groups LSAs for periodic refresh. OSPFv3 refreshes self-originated LSAs approximately once every 30 minutes. When OSPFv3 refreshes LSAs, it considers all self-originated LSAs whose age is from 1800 to 1800 plus the pacing group size. Grouping LSAs for refresh allows OSPFv3 to combine refreshed LSAs IPv6 Commands 980