Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 887
timers, update-source, no timers
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 887 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches timers Use this command in Peer Template Configuration mode to configure the keepalive and hold timers in a peer template. Default Format Mode The keepalive and hold timers default to the globally configured values set with the address-family command. timers keepalive holdtime Peer Template Config Parameter keepalive holdtime Description The time, in seconds, between BGP KEEPALIVE packets sent to a neighbor. The range is 0 to 65,535 seconds. Jitter is applied to the keepalive interval. The time, in seconds, that BGP continues to consider a neighbor to be alive without receiving a BGP KEEPALIVE or UPDATE packet from the neighbor. If no KEEPALIVE is received from a neighbor for longer than the hold time, BGP drops the adjacency. If the hold time is set to 0, then BGP does not enforce a hold time and BGP does not send periodic KEEPALIVE messages. The range is 0 to 65,535 seconds. no timers This command reverts the keep alive and hold time for a peer template to their defaults. After executing this command, the BGP peer must be reset before the changes will take effect. Format Mode no timers Peer Template Config update-source Use this command in Peer Template Configuration mode to configure a peer template to use a specific interface as the source for the TCP connection with a neighbor. You can enter an interface in the unit/slot/port format or a loopback interface in the loopback number format. Default Format Mode When no update source is configured, TCP connections use the primary IPv4 address on the outgoing interface to the neighbor. update-source [unit/slot/port | loopback number] Peer Template Config Border Gateway Protocol Commands 887