Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 776
displayed in DD:HH:MM:SS format., One of Con d, Startup, Resource Limitation.
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 776 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches Term Definition Maximum Paths The maximum number of paths that OSPF can report for a given destination. Default Metric Default value for redistributed routes. Stub Router Configuration When OSPF runs out of resources to store the entire link state database, or any other state information, OSPF goes into stub router mode. As a stub router, OSPF reoriginates its own router LSAs, setting the cost of all nonstub interfaces to infinity. Use this field to set stub router configuration to one of Always, Startup, None. Stub Router Startup Time Configured value in seconds. This row is only listed if OSPF is configured to be a stub router at startup. Summary LSA Metric Override One of Enabled (met), Disabled, in which met is the metric to be sent in summary LSAs when in stub router mode. Default Route Advertise Indicates whether the default routes received from other source protocols are advertised or not. Always Shows whether default routes are always advertised. Metric The metric of the routes being redistributed. If the metric is not configured, this field is blank. Metric Type Shows whether the routes are External Type 1 or External Type 2. Number of Active The number of active OSPF areas. An active OSPF area is an area with at least one interface up. Areas ABR Status Shows whether the router is an OSPF Area Border Router. ASBR Status Reflects whether the ASBR mode is enabled or disabled. Enable implies that the router is an autonomous system border router. The router automatically becomes an ASBR when it is configured to redistribute routes learnt from other protocols. The possible values for the ASBR status is enabled (if the router is configured to redistribute routes learned by other protocols) or disabled (if the router is not configured for the same). Stub Router Status One of Active, Inactive. Stub Router Reason One of Configured, Startup, Resource Limitation. Note: The row is only listed if stub router is active. Stub Router Startup Time Remaining The remaining time, in seconds, until OSPF exits stub router mode. This row is only listed if OSPF is in startup stub router mode. Stub Router Duration The time elapsed since the router last entered the stub router mode. The row is only listed if stub router is active and the router entered stub mode because of a resource limitation. The duration is displayed in DD:HH:MM:SS format. External LSDB Overflow When the number of nondefault external LSAs exceeds the configured limit, External LSDB Limit, OSPF goes into LSDB overflow state. In this state, OSPF withdraws all of its self-originated nondefault external LSAs. After the Exit Overflow Interval, OSPF leaves the overflow state, if the number of external LSAs has been reduced. External LSA Count The number of external (LS type 5) link-state advertisements in the link-state database. Routing Commands 776