Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 75

M5300, M6100, and M7100 Series ProSAFE Managed Switches no network mac-type This command resets the value of MAC address to its default. Format Mode no network mac-type Privileged EXEC network javamode This command specifies whether or not the switch should allow access to the Java applet in the header frame of the Web interface. When access is enabled, the Java applet can be viewed from the Web interface. When access is disabled, the user cannot view the Java applet. Default Format Mode enabled network javamode Privileged EXEC no network javamode This command disallows access to the Java applet in the header frame of the Web interface. When access is disabled, the user cannot view the Java applet. Format Mode no network javamode Privileged EXEC show network This command displays configuration settings associated with the switch's network interface. The network interface is the logical interface used for in-band connectivity with the switch via any of the switch's front panel ports. The configuration parameters associated with the switch's network interface do not affect the configuration of the front panel ports through which traffic is switched or routed. The network interface is always considered to be up, whether or not any member ports are up; therefore, the show network command always shows Interface Status as Up. Note: The network interface is not supported in software version 11.0. You can use the show network command only if you already configured the network interface in software version 10.0 and then upgraded to software version 11.0. However, in that case, NETGEAR recommends that you reconfigure the management IP address with the ezconfig command. Management Commands 75