Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 970

M5300, M6100, and M7100 Series ProSAFE Managed Switches no area nssa translator-stab-intv (OSPFv3) This command disables the nssa translator's stabilityinterval from the specified area id. Format Mode no area area-id nssa translator-stab-intv stabilityinterval Router OSPFv3 Config area range (OSPFv3) Use this command to configure a summary prefix that an area border router advertises for a specific area. Default Format Mode No area ranges are configured by default. No cost is configured by default. area area-id range prefix netmask {summarylink | nssaexternallink} [advertise | not-advertise] [cost cost] Router OSPFv3 Config Parameter area-id prefix netmask summarylink nssaexternallink advertise not-advertise cost Description The area identifier for the area whose networks are to be summarized. The summary prefix to be advertised when the ABR computes a route to one or more networks within this prefix in this area. When this keyword is given, the area range is used when summarizing prefixes advertised in type 3 summary LSAs. When this keyword is given, the area range is used when translating type 7 LSAs to type 5 LSAs. [Optional] When this keyword is given, the summary prefix is advertised when the area range is active. This is the default. [Optional] When this keyword is given, neither the summary prefix nor the contained prefixes are advertised when the area range is active. When the not-advertise option is given, any static cost previously configured is removed from the system configuration. [Optional] If an optional cost is given, OSPF sets the metric field in the inter-area -prefix LSA to the configured value rather than setting the metric to the largest cost among the networks covered by the area range. no area range The no area range command deletes a summary prefix or removes a static cost. Format Mode no area area-id range prefix netmask {summarylink | nssaexternallink} cost Router OSPFv3 Config IPv6 Commands 970