Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 1193

M5300, M6100, and M7100 Series ProSAFE Managed Switches Note: This command only applies when at least one module has PoE capability show poe port configuration Use this command to see how the PoE ports are configured. You can display information based on each individual port or all the ports collectively. Format Mode show poe port configuration [port | all] Privileged EXEC User EXEC Command example: (NETGEAR Switch) #show poe port configuration all Admin Power Power Limit High Power Detection Intf Mode Priority Limit Type Mode Type (W) 0/1 Enable Low 15.400 User Defined Disable Auto 0/2 Enable Low 15.400 User Defined Disable Auto Command example: (NETGEAR Switch) #show poe port configuration 0/2 Admin Power Power Limit High Power Detection Intf Mode Priority Limit Type Mode Type (W) 0/2 Enable Low 15.400 User Defined Disable Auto show poe port info Use this command to get information about the status of the PoE ports. You can display information based on each individual port or all the ports collectively. The command displays only PSE-capable ports. Format Mode show poe port info [port | all] Privileged EXEC User EXEC Power over Ethernet Commands 1193