Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 443
authentication enable
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 443 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches authentication enable This command globally enables the Authentication Manager. Interface configuration takes effect only if the Authentication Manager is enabled with this command. Note: The Authentication Manager is supported on M6100 series switches only. Default Format Mode disabled authentication enable Global Config no authentication enable This command disables the Authentication Manager. Format Mode no authentication enable Global Config authentication order This command sets the order of authentication methods used on a port. The available authentication methods are Dot1x, MAB, and captive portal. Ordering sets the order of methods that the switch attempts when trying to authenticate a new device connected to a port. If one method is unsuccessful or timed out, the next method is attempted. Each method can only be entered once. Ordering is only possible between 802.1x and MAB. Captive portal can be configured either as a stand-alone method or as the last method in the order. Note: This command is supported on M6100 series switches only. Format Mode authentication order {dot1x [mab [captive-portal] | captive-portal] | mab [dot1x [captive-portal]| captive-portal] | captive-portal} Interface Config no authentication order This command returns the port to the default authentication order. Format Mode no authentication order Interface Config Switching Commands 443