Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 884
activate, connect-retry-interval, no address-family
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 884 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches (R1) (Config-rtr-tmplt-af)# send-community (R1) (Config-rtr-tmplt-af)# route-map RM6-IN in (R1) (Config-rtr-tmplt-af)# route-map RM6-OUT out (R1) (Config-rtr-tmplt-af)# exit (R1) (Config-rtr-tmplt)# exit (R1) (Config-router)# neighbor 172.20.1.2 inherit peer AGGR (R1) (Config-router)# neighbor 172.20.2.2 inherit peer AGGR (R1) (Config-router)# address-family ipv6 (R1) (Config-router)# neighbor 172.20.1.2 activate (R1) (Config-router)# neighbor 172.20.2.2 activate no address-family To delete all policy commands for an address family in a peer template, use the no address-family command. Format Mode no address-family {ipv4 | ipv6} Peer Template Config Parameter ipv4 ipv6 Description Delete policy parameters for IPv4 routes. Delete policy parameters for IPv6 routes. activate Use this command to enable IPv6 unicast exchange in a peer template. Format Mode activate Address Family IPv6 connect-retry-interval Use this command in Peer Template Configuration mode to add it to a peer template to configure a connection retry interval. If a neighbor does not respond to an initial TCP connection attempt, NETGEAR Managed Switch retries three times. The first retry is after the retry interval configured with the command neighbor connect-retry-interval on page 860. Each subsequent retry doubles the previous retry interval. So by default, the TCP connection is retried after 2, 4, and 8 seconds. If none of the retries is successful, the adjacency is reset to the IDLE state and the IDLE hold timer is started. BGP skips the retries and transitions to IDLE state if TCP returns an error, such as destination unreachable, on a connection attempt. Border Gateway Protocol Commands 884