Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 694

M5300, M6100, and M7100 Series ProSAFE Managed Switches ip prefix-list description To apply a text description to a prefix list, use the ip prefix-list description command in Global Configuration mode. Default Format Mode No description is configured by default. ip prefix-list list-name description text Global Configuration Parameter list-name description text Description The text name of the prefix list. Text description of the prefix list. Up to 80 characters. no ip prefix-list description To remove the text description, use the no ip prefix-list description command. Format Mode no ip prefix-list list-name description Global Configuration ipv6 prefix-list (routing policy commands) Use this command to create IPv6 prefix lists. An IPv6 prefix list can contain only ipv6 addresses. Prefix lists allow matching of route prefixes with those specified in the prefix list. Each prefix list includes of a sequence of prefix list entries ordered by their sequence numbers. A router sequentially examines each prefix list entry to determine if the route's prefix matches that of the entry. For IPv6 routes, only IPv6 prefix lists are matched. An empty or nonexistent prefix list permits all prefixes. An implicit deny is assumed if a given prefix does not match any entries of a prefix list. Once a match or deny occurs the router does not go through the rest of the list. An IPv6 prefix list may be used within a route map to match a route's prefix using the match ipv6 address command. A route map may contain both IPv4 and IPv4 prefix lists. If a route being matched is an IPv6 route, only the IPv6 prefix lists are matched. Up to 128 prefix lists may be configured. The maximum number of statements allowed in prefix list is 64. These numbers indicate only IPv6 prefix lists. IPv4 prefix lists may be configured in appropriate numbers independently. Routing Commands 694