Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 890
show ip bgp, command in Privileged
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 890 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches Note: To display the debug trace, enable the debug console command. Default Format Mode No debug tracing is enabled by default debug ip bgp [peer-address | events | keepalives | notification | open | refresh | updates] Privileged EXEC Parameter peer-address events keepalives notification open refresh updates Description (Optional) The IPv4 or IPv6 address of a BGP peer. Debug traces are enabled for a specific peer when this option is specified. The command can be issued multiple times to enable simultaneous tracing for multiple peers. (Optional) Trace adjacency state events. (Optional) Trace transmit and receive of KEEPALIVE packets. (Optional) Trace transmit and receive of NOTIFICATION packets. (Optional) Trace transmit and receive of OPEN packets. (Optional) Traces transmit and receive of ROUTE REFRESH packets. (Optional) Traces transmit and receive of UPDATE packets. show ip bgp To view routes in the BGP routing table, use the show ip bgp command in Privileged EXEC mode. The output lists both best and nonbest paths to each destination. Format Mode show ip bgp [network/pfx-len [longer-prefixes | shorter-prefixes [length]] | filter-list as-path-list | prefix-list pfx-list-name] Privileged EXEC Parameter Description network/pfx-len (Optional) Display a specific route identified by its destination prefix longer-prefixes (Optional) Used with the network/pfx-len option to show routes whose prefix length is equal to or longer than pfx-len. This option may not be given if the shorter-prefixes option is given. shorter-prefixes and length (Optional) Used with the network/pfx-len option to show routes whose prefix length is shorter than pfx-len, and, optionally, longer than a specified length. This option may not be given if the longer-prefixes option is given. filter-list as-path-list (Optional) Filter the output to the set of routes that match a given AS Path list. This option may not be given if a network/pfx-len option is given, or when a prefix list is given. pfx-list-name (Optional) Filter the output to the set of routes that match a given prefix list. This option may not be given if a network/pfx-len option is given or when a filter list is given. Border Gateway Protocol Commands 890