Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 394
show spanning-tree vlan, parameter is a list of VLANs or
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 394 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches Command example: (NETGEAR Switch) #show spanning-tree uplinkfast Uplinkfast is enabled. BPDU update rate : 150 packets/sec Uplinkfast Statistics Uplinkfast transitions (all VLANs 0 Proxy multicast addresses transmitted (all VLANs).. 0 show spanning-tree vlan This command displays spanning tree information per VLAN and also lists out the port roles and states along with port cost. The vlan-list parameter is a list of VLANs or VLAN-ranges separated by commas and with no embedded blank spaces. VLAN ranges are of the form "X-Y" where X and Y are valid VLAN identifiers and X< Y. The vlanid corresponds to an existing VLAN ID. Format Mode show spanning-tree vlan {vlanid | vlan-list} Privileged EXEC User EXEC Command example: (NETGEAR Switch) show spanning-tree vlan 1 VLAN 1 Spanning-tree enabled protocol rpvst RootID Priority 32769 Address 00:0C:29:D3:80:EA Cost 0 Port This switch is the root Hello Time 2 Sec Max Age 15 sec Forward Delay 15 sec BridgeID Priority 32769 (priority 32768 sys-id-ext 1) Address 00:0C:29:D3:80:EA Hello Time 2 Sec Max Age 15 sec Forward Delay 15 sec Aging Time 300 Interface Role Sts Cost Prio.Nbr 1/0/1 Designated Forwarding 3000 128.1 1/0/2 Designated Forwarding 3000 128.2 1/0/3 Disabled Disabled 3000 128.3 1/0/4 Designated Forwarding 3000 128.4 1/0/5 Designated Forwarding 3000 128.5 1/0/6 Designated Forwarding 3000 128.6 Switching Commands 394