Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 28
movemanagement Chassis Global Config, slot for chassis configuration, no member
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches no member This command removes a blade from the chassis. The unit is the identifier of the blade to be removed from the chassis. You execute this command on the primary management blade. Format Mode no member unit Chassis Global Config movemanagement (Chassis Global Config) This command moves the management functionality from one blade to the other. The fromunit is the identifier of the current management blade. The tounit is the identifier of the new management blade. Upon execution, the entire chassis (including all interfaces in the chassis) is unconfigured and reconfigured with the configuration on the new management blade. After the reload is complete, you must perform all chassis management capabilities on the new management blade. To preserve the current configuration across a management blade move, execute the copy system:running-config nvram:startup-config privileged EXEC command or save privileged EXEC command before you perform the management blade move. A management blade move causes all routes and layer 2 addresses to be lost. You execute this command is executed on the management blade. The system prompts you to confirm the management blade move. Note: You can only configure the blade in slot 1 or slot 2 as a management blade. Format Mode movemanagement fromunit tounit Chassis Global Config slot (for chassis configuration) This command configures a slot in the system. The unit/slot is the slot identifier of the slot. The cardindex is the index into the database of the supported card types, indicating the type of the card being preconfigured in the specified slot. The card index is a 32-bit integer. If a card is currently present in the slot that is unconfigured, the configured information will be deleted and the slot will be reconfigured with default information for the card. Format Mode slot unit/slot cardindex Global Config Note: Card index can be obtained by executing show supported cardtype command in User EXEC mode. Chassis Commands 28