Netgear XCM89UP Command Line Interface CLI User Manual Software Version 11.x - Page 411
interface, or for a specific mode access, trunk, or general. If you select a mode but do
View all Netgear XCM89UP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 411 highlights
M5300, M6100, and M7100 Series ProSAFE Managed Switches access port becomes a member of VLAN 1. If you configure the access port as a member of a VLAN that does not exist, an error occurs and the configuration does not change. Default Format Mode 1 (default VLAN) switchport access vlan vlan-id Interface Config no switchport access vlan This command resets the switch port access mode VLAN to its default value. Format Mode no switchport access vlan Interface Config show interfaces switchport Use this command to either display the switch port status for all interfaces, for a specific interface, or for a specific mode (access, trunk, or general). If you select a mode but do not specify the interface for the mode, the selected mode is displayed for all interfaces. Format Mode show interfaces switchport {[unit/slot/port] | {access | trunk | general} [unit/slot/port]} Privileged EXEC Command example: (NETGEAR Switch) #show interfaces switchport 1/0/1 Port: 1/0/1 VLAN Membership Mode: General Access Mode VLAN: 1 (default) General Mode PVID: 1 (default) General Mode Ingress Filtering: Disabled General Mode Acceptable Frame Type: Admit all General Mode Dynamically Added VLANs: General Mode Untagged VLANs: 1 General Mode Tagged VLANs: General Mode Forbidden VLANs: Trunking Mode Native VLAN: 1 (default) Trunking Mode Native VLAN tagging: Disable Trunking Mode VLANs Enabled: All Protected Port: False Command example: (NETGEAR Switch) #show interfaces switchport access 1/0/1 Intf PVID Switching Commands 411