LiftMaster TDC Installation Manual - English French Spanish - Page 29

Programming Quick Start Commissioning Follow the below instructions to provision the JHT operator out-of-the-box or after factory reset: Quick Start Commissioning Menu Follow device menu prompt to select DOOR HANGING Follow device menu prompt to select DOOR DRUM Follow device menu prompt to select DOOR SPROCKET (J/H ONLY) WARNING To prevent possible SERIOUS INJURY or DEATH: • Disconnect electric power BEFORE performing ANY adjustments or maintenance. • ALL maintenance MUST be performed by a trained door systems technician. • Please wait several seconds for capacitors to discharge and for display to go out. Follow device menu prompt to set OPEN LIMIT Follow device menu prompt to set CLOSE LIMIT Follow device menu prompt to LEARN WIFI The operator will be in WiFi Learn Mode for 10 minutes if "YES" is selected. Quick Exit of Menu Hold down the "UP" and red "Stop" buttons for 3 seconds until the screen goes blank and it will exit you out of the menu you are in. Quick Enter into the Menu Hold down the "Down" and red "Stop" buttons for 3 seconds until the screen goes blank and it will take you to the main menu. Manual Commissioning Program Flow IMPORTANT: All entrapment protection devices will be disconnected during the manual commissioning steps. The System Settings menus are password-protected. ENTER PROGRAMMING 1. Press the "STOP/ENTER" and "DOWN" buttons on the inside of the controller at the same time for 3+ seconds to enter the operator menu. If the controller is closed, press the "Stop" then "Close" then "Open" until the unit goes into program mode. 2. Scroll down to "SYSTEMS SETTINGS" with the "UP" and "DOWN" buttons and press "ENTER." You will be prompted to enter the password for the operator. 3. Enter 326 as the password. Door Settings SELECT DOOR TYPE SELECT DOOR TYPE SELECT DOOR TYPE Standard Lift High Lift Vertical Lift SELECT DOOR TYPE Rolling 29