HP ZBook Studio x360 Maintenance and Service Guide - Page 59
Fingerprint reader board, Remove the Phillips M2.0×2.5 screw
View all HP ZBook Studio x360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Fingerprint reader board Description Fingerprint reader board (includes bracket) Fingerprint reader board bracket Fingerprint reader cable Spare part number L28662-001 L28674-001 (Bracket Kit) L28668-001 (Cable Kit) Before removing the fingerprint reader board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 31). 5. Remove the battery (see Battery on page 33). Remove the fingerprint reader board: 1. Disconnect the cable from the fingerprint reader board ZIF connector (1). 2. Remove the Phillips M2.0×2.5 screw (2) that secures the fingerprint reader bracket to the computer. 3. Lift the bracket off the fingerprint reader (3). 4. Remove the fingerprint reader from the computer (4). Reverse this procedure to install the fingerprint reader board. Component replacement procedures 47