Xerox C2424 Service Manual - Page 282

Test Print Examples (Continued) 13-19: Black, Red, Green, Blue, Cyan, Magenta, and Yellow Solid Fills This prints show uniformity of fill. Look for: 1. There are even, uniform fills throughout the print. 2. There should be no wrinkling or deformity of the paper throughout the print. 3. You may see poor transfer on one side. 4. You may also see repeating white stripes. Causes: 1. Weak jets or uneven drum heating may cause uneven fills. 2. To solve wrinkling, try different print media. Replace the maintenance kit to correct streaking. Check the drum-temperature sensor for debris build-up on the sensor or the sensor is not in proper contact with the drum. See the test print Reverse Text. 3. If there is poor transfer on one side, check to see if the transfix load arm assemblies are moving easily. Clean any contamination that may be interfering with the transfix arm assembly movement. If either of the transfix load arm assemblies are worn, replace the worn load arm assembly. 4. If there are repeating white stripes on the print, there may be a problem with the X-Axis motion, see "White Stripes (Pinstripes)" on page 32. 20: OHP Color Bands This print is used by Manufacturing and Engineering. s2424-098 5-42 WorkCentre C2424 Service Manual